Class-C-Power-Amplifier

Class-C-Power-Amplifier

CLASS C POWER AMPLIFIER
Download Class-C-Power-Amplifier.epb

Aim


To simulate a class C power amplifier circuit.

Components Required


Transistor- BC107A (1), Resistor - RC05 (2), Capacitor - CASE-A600 (1), InductorIND2825P (2), AC current source - IGEN (1), DC voltage source - VDC (2), Ground- SPL0 (2)

Circuit Diagram


Procedure


1.Draw the circuit diagram after loading components from library. Assign net names for connections wherever necessary. Preprocess the circuit by invoking Simulation → Preprocess. Place waveform markers on input and output nodes.

2.For placing waveform markers, select Tools → Instruments → set wave form Contents → Voltage waveform → Click on the required net and place the waveform marker. Run transient analysis after setting up required parameters.

3.Select Tools → Components → Component properties→ Change simulation parameters→ Click on the required component and change its values.

The values to be provided to the components are

        Transistor : BC107A (Click on the Set up Model of the Model Type. Click on Accept to get the default values assigned)
        Resistors : R = 10k, R 1 = 100k
        Capacitor : C = 1µF
        Inductors : L = 200mH, L 1 = 50mH
        VDC/1 (+Vcc) : 5V
        VDC/2(-Vbb) : -1V 1 = 50mH
        VGEN : Select the source function as SIN and set its Properties as follows
                    VA (amplitude) : 10mA
                    FREQ (frequency) : 500Hz   

4.For setting up simulation time and analysis types, select Simulation menu, choose Analysis. In the window pops up, select Transient analysis from tree view.

    Enter following values:
          Step : 1µ
          Final time : 25m
          Results : Select Waveform from drop down menu.
5.Click on Accept. Expand the Transient Analysis and select Waveform viewer, Select As Marked. Click on Accept. Select Transient Analysis. Run Analysis by clicking on Run button.

Result